Korg Pa4X User Manual page 750

736| Effects for the Sounds
i Low Gain [dB]
High Gain [dB]
j Wet/Dry
Src
Amt
e: Formant Shift
By offsetting the Carrier filter, you can adjust the height of the frequency
range to which the vocoder effect is applied. The tonal quality will change
significantly.
g: Noise Level
This parameter enables you to mix white noise with the Carrier.
h: Modulator High Mix
This parameter sets the high-range output level of the modulator sound. If
the modulator is a human voice, it will make the words more clear.
Using the vocoder with the microphone input
When programming the Vocoder, you can start from one of the specially pro-
grammed Vocoder
To use a voice from a microphone as a modulator:
1 Press the MIC
2 Connect a microphone to the Mic Input.
3 Set Modulator Source
4 Speak into the microphone while you use the
input) to adjust the level as high as possible without allowing distortion to
occur.
With these settings, the sound from the microphone will be used as the mod-
ulator. While you play, speak into the mic; it will sound as though the instru-
ment is talking.
If the effect sound is distorted, adjust the
Please remember to set the Carrier track's
Send value to 127.
–12...+12
–12...+12
Dry, 1:99...99:1,
Wet
Off...Tempo
–100...+100
Keyboard Sets (in the
button to turn the microphone channel off.
to FX Control
Sets the low-range output level of the vocoder
Sets the high-range output level of the vocoder
Balance between the wet and dry signal
See DMS (Dynamic Modulation Source)
Amount of modulation source
Synth group) as templates.
1.
GAIN
Carrier Trim
Dry parameter to Off, and the
knob (next to the
and Modulator Trim.
MIC