Korg Pa4X User Manual page 431

The actual amount of pitch change will depend on the Pitch EG > Intensity
parameters (see the Sound > Pitch > Pitch Mod page). For example, with an
Intensity setting of +12.00, a Level setting of +99 would raise the pitch one
octave, and a Level setting of –99 would lower the pitch one octave.
▪
Use the Time
change will occur.
EG time
Attack
Decay
Release
Modulating the Pitch EG
Modulating the Pitch EG levels
Use the Level Modulation > AMS 1/2
source for the
▪
Use the Level Modulation > Intensity
depth and direction of the modulation generated by
setting of 0, the levels specified by the
For example, if you choose the Joystick Y+ the AMS, moving the Joystick
in the upper direction to turn it on will change the Level parameters of the
Pitch EG. As the absolute value of Intensity is increased, the Pitch EG levels
will change more when the Joystick is released. The direction of the change
is specified by St (Start Level Swing) and At (Attack Level Swing). When the
Joystick is released, the Pitch EG levels will return to their own settings.
If you choose the Velocity AMS, increasing the absolute value of Intensity
will produce increasingly wider change in Pitch EG levels for strongly-played
notes. The direction of the change is specified by St (Start Level Swing) and
At (Attack Level Swing). As you play more softly, the pitch change will draw
closer to the Pitch EG levels.
▪
Use the St (Start Level Swing)
to specify the direction of change in Level > Start and Level > Attack caused
by the AMS.
parameters (0...99) to specify the time over which the pitch
Meaning
Time over which the pitch will change from note-on until it reaches
the pitch specified as the attack level.
Time over which the pitch will change after reaching the attack level
until it reaches the normal pitch.
Time over which the pitch will change from note-off until it reaches
the pitch specified as the release level.
Pitch EG > Level parameters.
and the At (Attack Level Swing) parameters
Editing the Sounds |417
parameters to select a modulation
parameters (-99...+99) to specify the
AMS1
Level parameter will be used.
or AMS2. With a