Accelerator Pedal; Steering System; Steering Shaft - Factory Five Racing MK4 ROADSTER Assembly Manual

Cut the accelerator pedal capture in the corner using a pair of wire cutters.
Slip the accelerator cable through the cut so that the ball will sit in the recess.
Push the capture into the end of the throttle pedal.
Check the idle screw underneath the throttle body to see if the throttle arm is hitting it. If it is not, the
small tab behind the accelerator pedal may be stopping the plate from closing. Bend it up until the idle
screw hits the throttle arm. You will notice a fairly high idle later when the car starts if this has not been
done.Use the accelerator cable without modification. Follow the installation instructions above.

Accelerator Pedal


" hex key,
3 / 7 /
16 16

OEM accelerator pedal, accelerator cable components
Hold the accelerator pedal up to the mount on the ¾" tube at the front of the foot box. The higher you
can mount the pedal the better the pedal will be positioned on your foot. The key things to watch for is
clearance between the accelerator pedal and clutch quadrant stop and keeping the cable straight so it will
not rub on the side of the cable sheath. If a higher location is desired, some material can be removed
from the bottom of the clutch quadrant stop. If mounting higher, mark and drill new holes for the bolts
in the pedal.
Attach the accelerator pedal to the mount using the ¼"x ¾" bolts, washers and lock nuts.
Cut the accelerator pedal capture in the corner using a pair of wire cutters.
Slip the accelerator cable through the cut so that the ball will sit in the recess.
Push the capture into the end of the throttle pedal.

Steering System

Steering Shaft


", " hex keys, ½",
/
3 5/
16 16
screwdriver, 15mm deep socket, ratchet.

Steering bearings/Hardware, Steering shaft.
Unpack the steering shaft assembly.
" wrench, pliers
", 10mm wrenches, marker, drill,
/
9
16
www.factoryfive.com
" drill bit, Phillips head
/
3
16
176
508-291-3443