Cut one full coil from the top of the spring for correct ride height setting.
Cut the upper rubber spring seat so that during assembly of the kit, it will conform to the spring mount
on the frame. This is done with one cut across the part. Do not replace these bushings with aftermarket
silicone pieces, as these will allow the springs to slide since they contain a slippery release agent in
them.
Rear End
½" drill bit, drill, vise
Remove and save the control arms from the axle
Remove the lower shock mount brackets.
Using a ½" drill bit, enlarge the hole on the Ford lower shock mount brackets.
The lower shock mount brackets will get used on the front lower control arms to mount the front
shocks
See the Solid Axle suspension section of the manual for more solid axle preparation.
Front Lower Control Arms
Hack saw, file grinder
52
www.factoryfive.com
508-291-3443