Accelerator Pedal - Factory Five Racing MK4 ROADSTER Assembly Manual

Make sure that the master cylinder pushrods remain true in relationship to the cylinder during entire pedal
travel; pushrods should not be pushing master cylinder pistons at an angle.

In its non-depressed position, the pedal and balance bar should allow the pushrod of the master cylinders
to fully return. This can be checked by feeling pushrods for very slight movement, not loose movement.
Master cylinder pistons should be against the retaining snap ring (under boot).

Accelerator Pedal


" hex key, ⅜",
5 /
64

Accelerator cable components, accelerator pedal components, pedal box hardware.

The Accelerator cable is designed to be used with all types of engines, carbureted or fuel injected. The
stock cable has the barrel end on it for the 4.6L throttle body and the ball for a Mustang accelerator
pedal.
Unpack the throttle pedal and separate the arms. You can leave the screw loose for now as this will be adjusted
for fit later.
", ½" wrenches, wire cutter, ¼" drill bit, drill, marker, masking tape.
7 /
16
www.factoryfive.com
134
508-291-3443