Factory Five Racing MK4 ROADSTER Assembly Manual page 359

Center the body over the frame using a tape measure to measure from the lip of the body to the rear
mounting plate of the front coil-over bracket. Check the alignment to make sure the tape measure is
going straight across the car by lining it up with the front "X" member so that the tape measure is
parallel. Make this measurement on each side of the body so that the front of the body is centered over
the frame.
Move the front of the body as necessary. If the body will not stay where you put it, put a screw through
the hood lip of the body into the ¾" tube.
The hood opening is attached to the ¾" frame rails using countersunk sheet metal screws or the small
bumpers during the hood fitment next.
With the Body centered left to right and the quick jack sleeves centered in the holes, tighten the bolts.
Use a jack temporarily hold the bottom side of the body up to the frame.
358
www.factoryfive.com 508-291-3443