Factory Five Racing MK4 ROADSTER Assembly Manual page 361

The hood has been trimmed slightly oversized to allow the panel gaps to be sanded down to fit. Set the
hood in place and make sure it will fit the opening in the body, if needed sand or file the edges to allow
the panel to just fit with a very small gap all around.

The bumpers are used to get the hood to the correct plane with the body, you can shave small
amounts off either or put washers as shims to fine tune as needed.
Put the small bumpers around the edge of the hood opening and try closing the hood. If it is too low try
the large bumpers.
360
www.factoryfive.com 508-291-3443