Carbureted Applications - Factory Five Racing MK4 ROADSTER Assembly Manual

Carbureted applications

If necessary, attach the supplied ball stud to the carburetor in the appropriate location. Refer to the
carburetor instructions for placement.
Attach the ball stud retainer to the ball stud.
Pull the cable tight holding the cable against the ball stud retainer. Align the ball stud retainer with the
cable as if the cable was going into the retainer.
Mark on the cable where the retainer ends.
Measure ⅜" from the mark on the cable towards the end of the cable and re-mark the cable.
Using a pair of wire cutters, cut the cable at the new location marked.
Push and twist the ball stud retainer onto the end of the cable. Do not tighten the set screw yet.
283
www.factoryfive.com 508-291-3443