Factory Five Racing MK4 ROADSTER Assembly Manual page 126

Driver Side
Install the kit ½"x 4" bolts are provided for each lower shock mount. From the rear, the bolt goes
through the bracket, ⅛" shim, shock, then the long spacer (1.09") followed by the bracket and axle. Use
a ¾" socket and Torque wrench to tighten both upper and lower mounts to 40 ft-lbs.
Check for shock clearance on brake lines, emergency brake cables, brake calipers, frame and axle parts.
Check to make sure that the spring is seated correctly on the shock.
125
www.factoryfive.com 508-291-3443