87-95 Oil Filter Relocator - Factory Five Racing MK4 ROADSTER Assembly Manual

Check the pulley wheel for alignment with the other pulleys so that premature belt wear does not occur.
With one eye, carefully align the front side of the pulley with the front side of the other pulleys. If the
new pulley is not lined up properly and is too far in, use the arbor shims included with the kit to go
between the aluminum sleeve and the pulley wheel, effectively pushing the assembly outwards.

87-95 Oil Filter Relocator


⅞" wrench, razor knife, Teflon tape, chassis grease, ⅜" hex key

Oil filter relocating kit, oil, oil filter
Place the O-ring in the adapter groove.

If the O-ring will not seat properly, put it in the freezer for 15 minutes and use a small amount of
chassis grease to hold it in place while spinning on the adapter. Tighten ½ turn after solid
resistance is felt. The outlets for the hoses should be facing towards the front of the engine.
Install the oil filter relocate base plate on the engine.
Install the block off plugs (with a ⅜" hex key) in the adapter holes not being used. Use the Teflon tape
on the threads of the plugs as you tighten them. Wrap the Teflon tape so it stretches when you attach the
plug into the threaded socket. Max torque for the fittings on the relocate kit is 28 lbft.
254
www.factoryfive.com 508-291-3443