Link Rear Suspension Torque Specs Chart - Factory Five Racing MK4 ROADSTER Assembly Manual

Attach the Panhard bar to the frame mount using the spacers provided.
There should never be less than ¾" of threads screwed into either the Panhard bar or the upper arm.
To set the pinion angle, make sure that your ride height is where you want it, and then adjust the upper
arm until the desired angle is reached. We usually run about 2° up on the rear axle, but you can adjust
this to fit your particular set-up.
The Panhard bar can center the axle left to right in the frame.
At ride height, level the Panhard bar as much as possible.
Double check all your nuts and bolts, and make sure that all four jam nuts are tight.

3 link Rear Suspension Torque Specs Chart


With the rear end correctly installed with the 3-link, the rear axle will rest on the 3-link panhard
bar mount with the suspension at full droop.

If using the stock Mustang shocks, skip the next section.
Item
Upper link to axle
Upper link to frame
Lower control arm to axle
Lower control arm to frame
Upper shock to frame
Lower shock to axle bracket
Panhard bar
www.factoryfive.com
Nm Lbft
101-111 75-82
101-111 75-82
101-111 75-82
101-111 75-82
54-67 40-50
54-67 40-50
101-111 75-82
120
508-291-3443