Factory Five Racing MK4 ROADSTER Assembly Manual page 331

Line the dash up with the hoop on the chassis. The corners of the dash support tube are
top edge of the dash. The tube will be lower as it goes to the middle.
Make sure the gauges do not hit the ¾" tubing.
Drill for the dash mounting screws (5 evenly spread) through the dash and chassis with a
then drill back through the dash only with a
Screw the dash to the dash support hoop using the Phillips head screws with countersunk washers.
Optional gauges shown.
" bit and screw the dash to the chassis.
/
3
16
330
www.factoryfive.com 508-291-3443
" below the
3 /
16
" drill bit
/
1 8