Factory Five Racing MK4 ROADSTER Assembly Manual page 324

Install the large gauges with the taller spacers and the smaller gauges with the shorter spacers that are
included with the kit so that the faces of the gauges stand away from the back face of the aluminum dash
panel. This distance has been pre-set at the factory so that the sweep hands of each gauge fit.
The blue light will light when the high beams are on.
Connect one lead from the blue light to the black wire and the other lead to the second 4 conductor 2'
section.
Attach the other end of the same wire to:
87-93 the gray plug pin #2 (Dimmer to High Beams) using red connectors.
96-98 Attach the other end of the same wire to the High beam indicator (+).
99-04 Attach the other end of the same wire to the Power – Hot w/high beams on.
The red light is check engine or charge. Use wires and run them to the appropriate bulb on the white
pod. The green light is for turn signals.
323
www.factoryfive.com 508-291-3443