96-04 Heater bypass hose
Use the heater bypass hose provided to loop between the inlet and outlet on the back of the engine.
96-04 Oil pan
" deep socket,
9
/
16
If you are installing aftermarket gauges, some of the gauge sending units will need to be
changed. Do this now while the engine is empty and out of the car. See your gauge instructions
for more information.
The stock 4.6L oil pan is too deep and must be changed for a shallower pan. These are available
from Canton and Morosso.
Change the Oil pan now.
Engine/Transmission Installation
Engine hoist, chain, ¾",
Engine, Polyurethane engine/transmission mount kit
Locate the pin stamped VIN number on the engine and the transmission. Some states check for
these numbers during registration and they are hard to see on the 4.6. It may be useful to take
pictures of these for the inspector. The engine VIN is located on the drivers' side on the engine
block just above the oil pan near the bellhousing (it is very small). The Transmission VIN
number is on the drivers' side in front of the Speedo sensor near the middle of the transmission
(it is very small).
", ½" wrenches.
9
/
16
" sockets, ratchet, extension
15
/
16
www.factoryfive.com
260
508-291-3443