Factory Five Racing MK4 ROADSTER Assembly Manual page 68

87-95 - Bend the fuel lines away from the engine block just at the point where they are held in place by
the retaining clips. This is so that the fuel does not travel near the hot header. Don't make tight bends
here or it will affect your fuel flow.
If you are using a Lakewood bell housing, trim the area around the starter so that is flush with the
inspection cover.
If you are not running emissions equipment, the only engine controls that need vacuum are the PCV
valve in the valve cover and the fuel pressure regulator. The EGR can be left unhooked. Make sure to
close off any extra vacuum ports.
If you are not running emissions equipment, the hoses, mounts and solenoids can be removed.
87-95 - Install the headers using the header originally for the left side on the right side of the engine, and
the right header on the left side of the engine. Thread all of the bolts on the headers before tightening
any of them, to make installation easier.
67
www.factoryfive.com 508-291-3443