Configuring The Nrs Database; Procedure 4 - Nortel SRG200 Configuration Manual

Page 66 of 254 Dialing Plan configuration
NN43001-308 Standard 01.02
CLTP NATL
...
SPN 1015
FLEN 10
...
RLI 30
CLTP LOCL
...
SPN 1016
FLEN 10
...
RLI 30
CLTP LOCL
...

Procedure 4

Configuring the NRS database

After configuring main office routing to the NRS, the NRS database must be
provisioned to identify the desired endpoint for the calls. This procedure
configures the NRS database with the inserted digits specified by the zone-
based digit manipulation configuration.
Instead of configuring the NRS database, you can configure a route in the
main office to directly route the call (see step 4 on
This procedure provides information specific to the configuration of the NRS
database for this application.
Installation and Commissioning
1 Click the Configuration tab in NRS.
2 Click set Standby DB view to work in the standby (inactive) database.
3 Select Routing entries from the navigation menu on the left-hand side of
the Network Routing Service window.
The Routing Entries window opens, as shown in Figure 5 on
May 2007
7 digits for long-distance + 3 digits for ZDP
7 digits for long-distance + 3 digits for ZDP
For more information, see IP Peer Networking
(NN43001-313)
page 63).
.
page 67.