Advertisement
Operation
Alarms Menu
Contact Information
Alarms Menu
3-68
Model 48i Instruction Manual
Note If the analyzer is in service mode, pressing
selected item between yes and no (with the exception of dilution ratio and
auto calibration, which may be only enabled at the factory).
In the Main Menu, choose Diagnostics > Instrument Configuration.
●
INSTRUMENT CONFIGURATION:
>I/O EXPANSION BOARD
ZERO/SPAN VALVES
ZERO AIR SCRUBBER
WHEEL PURGE
DILUTION
RANGE
AVG
AUTO CALIBRATION
O2 SENSOR
The Contact Information screen displays the customer service information.
In the Main Menu, choose Diagnostics > Contact Information.
●
CONTACT INFORMATION:
CALL CENTER: 508-520-0430
WEB:
RANGE
AVG
The Alarms menu displays a list of items that are monitored by the
analyzer. If the item being monitored goes outside the lower or upper limit,
the status of that item will go from "OK" to either "LOW" or "HIGH",
respectively. If the alarm is not a level alarm, the status will go from "OK"
to "FAIL". The number of alarms detected is displayed to indicate how
many alarms have occurred. If no alarms are detected, the number zero is
displayed.
To see the actual reading of an item and its minimum and maximum
limits, move the cursor to the item and press
Items displayed are determined by the options installed. The zero/span
check and auto calibration screens are visible only if the zero/span check or
auto calibration options are enabled. The O
item is only displayed if the internal O
motherboard status, interface board status, and I/O Expansion board status
YES
YES
YES
YES
NO
DIAGS ALARM
NO
YES
WWW.THERMO.COM
DIAGS ALARM
Concentration Alarm menu
2
sensor option is installed. The
2
will toggle the
▲
.
Thermo Fisher Scientific
Hide quick links:
Advertisement
Troubleshooting
