Quidway S2700 Series Ethernet Switches
Configuration Guide - Security
Procedure
l
----End
Example
Run the display flow-suppression interface interface-type interface-number command, and
you can view the configuration of traffic suppression on a specified interface.
<Quidway> display flow-suppression interface gigabitethernet 0/0/1
storm type
-------------------------------------------------------------------------------
unknown-unicast
multicast
broadcast
-------------------------------------------------------------------------------
8.4 Configuration Examples
This section provides several configuration examples of traffic suppression.
8.4.1 Example for Configuring Traffic Suppression
Networking Requirements
As shown in
limit the number of broadcast, multicast, or unknown unicast packets forwarded on the Layer 2
network, you can configure traffic suppression on GE 0/0/1.
Figure 8-1 Networking diagram for configuring traffic suppression
Configuration Roadmap
Configure traffic suppression in the interface view of GE 0/0/1.
Data Preparation
To complete the configuration, you need the following data:
l
Issue 01 (2011-07-15)
Run the display flow-suppression interface interface-type interface-number command to
check the configuration of traffic suppression.
rate mode
percent
percent
percent
Figure
8-1, the Switch is connected to the Layer 2 network and Layer 3 router. To
GE0/0/1
L2 network
GE 0/0/1 where traffic suppression is configured
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
set rate value
percent: 80%
percent: 80%
percent: 80%
GE0/0/2
Switch
8 Traffic Suppression Configuration
L3 network
154