Table of Contents
Advertisement
P54A/B/C/E
5.8.4
PRP/HSR DEVICE IDENTIFICATION
To configure the redundant Ethernet board, go to the main window and click the Identify Device button. A list of
devices are shown with the following details:
Device address
●
MAC address
●
●
Version number of the firmware
SNTP IP address
●
Date & time of the real-time clock, from the board.
●
Select the device you wish to configure. The MAC address of the selected device is highlighted.
5.8.5
SELECTING THE DEVICE MODE
You must now select the device mode that you wish to use. This will be either PRP or HSR. To do this, select the
appropriate radio button then click the Update button. You will be asked to confirm a device reboot. Click OK to
confirm.
5.8.6
PRP/HSR IP ADDRESS CONFIGURATION
To change the network address component of the IP address:
1.
From the main window click the IP Config button. The Device setup screen appears.
2.
Enter the required board IP address and click OK. This is the redundancy network address, not the IEC 61850
IP address.
3.
The board network address is updated and displayed in the main window.
5.8.7
SNTP IP ADDRESS CONFIGURATION
To Configure the SNTP server IP address:
1.
From the main window click the SNTP Config button. The Device setup screen appears.
2.
Enter the required MAC SNTP address and server IP SNTP Address. Click OK.
3.
The updated MAC and IP SNTP addresses appear in the main screen.
5.8.8
CHECK FOR CONNECTED EQUIPMENT
To check what devices are connected to the device being monitored:
1.
From the main window, select the device.
2.
Click the Equipment button.
3.
At the bottom of the main window, a box shows the ports where devices are connected and their MAC
addresses.
5.8.9
PRP CONFIGURATION
To view or configure the PRP Parameters:
1.
Ensure that you have set the device mode to PRP.
2.
Click the PRP/HSR Config button. The PRP Config screen appears.
3.
To view the available parameters, click the Get PRP Parameters button.
4.
To change the parameters, click the Set Parameters button and modify their values.
If you need to restore the default values of the parameters, click the Restore Defaults button.
P54xMED-TM-EN-1
Chapter 17 - Communications
363
Advertisement
Table of Contents
Troubleshooting
