GE P4A Technical Manual page 722

Appendix B - Settings and Signals
MENU TEXT
only be set using the .MCL file.
This setting allows for an Ethernet connection to be established with the relay without needing to first send a .MCL file via the serial port.
Once a connection has been established the correct .MCL can be sent via Ethernet and this setting can be changed back to "Disabled".
Note: You can enable this feature when you use the IED for the first time. However, the IED will at this point not have an active MCL file and
any data model extracted from IEC 61850 may not be correct. Therefore, to prevent any issues you should send a correct MCL file to the IED
after a
connection is first established.
IP PARAMETERS
IEC61850 versions only.
IP address
IEC61850 versions only. Displays the unique network IP address that identifies the IED.
Subnet mask
IEC61850 versions only. Displays the sub-network the IED is connected to.
Gateway
IEC61850 versions only. Displays the IP address of the gateway (proxy) that the IED is connected to, if any.
Media
IEC 61850 versions only. Displays the communication media of the Ethernet port that is currently in use.
IP address
IEC 61850 versions only. When IP From HMI is enabled this is used to set the unique network IP address that identifies the unit.
Subnet mask
IEC 61850 versions only. When IP From HMI is enabled this is used to set the sub-network mask.
Gateway
IEC61850 versions only. Set the IP address of the gateway (proxy) the relay is connected to via HMI if any.
Media
IEC 61850 versions only. Sets the communication media of the Ethernet port. For products with dual redundant fibre select the
1xCopper/2xFibre setting
SNTP PARAMETERS
IEC61850 versions only.
SNTP Server 1
IEC61850 versions only. Displays the IP address of the primary SNTP server.
SNTP Server 2
IEC61850 versions only. Displays the IP address of the secondary SNTP server.
IEC 61850 SCL
IEC61850 versions only.
IED Name
IEC61850 versions only. 8 character IED name, which is the unique name on the IEC 61850 network for the IED, usually taken from the SCL
file.
IEC 61850 GOOSE
IEC61850 versions only.
GoEna
IEC61850 versions only. Setting to enable GOOSE publisher settings.
Publisher Sim
B156
COL ROW DEFAULT SETTING
19 30
19 31
19 32
19 33
19 34 1xFibre Optic
19 38 0.0.0.0
19 39 0.0.0.0
19 3A 0.0.0.0
19 3B 1xFibre Optic
19 40
19 41
19 42
19 50
19 51
19 60
19 70 0x00000000
19 71 0x00000000
DESCRIPTION
IP address
[ASCII text]
Subnet mask
[ASCII text]
Gateway
[ASCII text]
0 or 1
[Indexed String]
IP address
[ASCII text]
Subnet mask
[ASCII text]
Gateway
[ASCII text]
0 or 1
[Indexed String]
SNTP Server 1
[ASCII text]
SNTP Server 2
[ASCII text]
IED Name
[ASCII text]
Disabled
Enabled
[Binary Flag (32)]
Disabled
Pass Through
Forced
[Binary Flag (32) Indexed String]
P54A/B/C/E
AVAILABLE OPTIONS
P54xMED-TM-EN-1