GE P4A Technical Manual page 732

Appendix B - Settings and Signals
MENU TEXT
kZm = ZM0/3Z1
Angle setting kZm is visible if 'Mutual Comp' is enabled. This setting is a used for fault locator and Distance protection (when set to simple
mode) . If Distance protection is set to Advanced mode, there are individual settings per Zone in the GROUP x DISTANCE ELEMENTS settings.
Phase Sequence
This setting is used to select whether the 3 phase quantities (V and I) are rotating in the standard ABC sequence, or whether the rotation is in
reverse ACB order. The appropriate selection is required to ensure that all derived sequence components and faulted phase
flagging/targeting are correct.
Tripping Mode
This setting is used to select the tripping mode. The selection 1 and 3 pole allows single pole tripping for single phase to ground faults, whilst
selection 3 pole converts any trip command(s) to three pole tripping.
Line Charging Y
Setting for protected lines' total susceptance in either primary or secondary terms, depending on the Setting Values reference chosen in the
CONFIGURATION column. The set value is used to calculate the compensated overvoltage if 'V1>1 Cmp Funct' setting is enabled under
GROUP x VOLT PROTECTION.
Multi-End Diff
Neutral Diff Heading
Topology
A map of the terminals and junctions in the system
Topology
B166
COL ROW DEFAULT SETTING
30 0B Standard ABC
30 0C 1 and 3 Pole
30 10 0.002
30 20
30 21 11
30 21 11
DESCRIPTION
Standard ABC
Reverse ACB
[Indexed String]
3 Pole
1 and 3 Pole
[Indexed String]
From 0*I2 to 0.01*I2 in steps of 0.0001
[Courier Number (inverse ohms)]
T2 J1
T3 J1
T4 J1
T5 J1
T6 J1
T1 J2
T2 J2
T3 J2
T4 J2
T5 J2
T6 J2
T1 J3
T2 J3
T3 J3
T4 J3
T5 J3
T6 J3
T1 J4
T2 J4
T3 J4
T4 J4
T5 J4
T6 J4
[Binary Flag (24) & Indexed String]
T2 J1
T3 J1
T4 J1
T5 J1
T6 J1
T1 J2
T2 J2
T3 J2
T4 J2
T5 J2
T6 J2
T1 J3
T2 J3
T3 J3
T4 J3
T5 J3
P54A/B/C/E
AVAILABLE OPTIONS
P54xMED-TM-EN-1