Rear Ethernet Port Copper; Rear Ethernet Port Fibre; 100 Base Fx Receiver Characteristics - GE P4A Technical Manual

Chapter 22 - Technical Specifications
Isolation
Constraints
Input signal
Input impedance
Accuracy
2.9

REAR ETHERNET PORT COPPER

Main Use
Standard
Connector
Cable type
Isolation
Supported Protocols
Constraints
2.10

REAR ETHERNET PORT FIBRE

Main Use
Connector
Standard
Fibre type
Supported Protocols
Optional Redundancy Protocols Supported
Wavelength
2.10.1

100 BASE FX RECEIVER CHARACTERISTICS

Parameter
Input Optical Power Minimum at
Window Edge
Input Optical Power Minimum at
Eye Center
Input Optical Power Maximum
Conditions: TA = 0°C to 70°C
510
IRIG-B Interface (Modulated)
Isolation to SELV level
Maximum cable length 10 m
peak to peak, 200 mV to 20 mV
6 k ohm at 1000 Hz
< +/- 1 s per day
Rear Ethernet port using CAT 5/6/7 wiring
Substation Ethernet communications
IEEE 802.3 10BaseT/100BaseTX
RJ45
Screened twisted pair (STP)
1.5 kV
IEC 61850, DNP3.0 OE
Maximum cable length 100 m
Rear Ethernet port using fibre-optic cabling
Sym Min.
PIN Min. (W)
PIN Min. (C)
PIN Max. -14
Substation Ethernet communications
IEC 874-10 BFOC 2.5 –(ST®) (1 each for Tx and Rx)
IEEE 802.3 100 BaseFX
Multimode 50/125 µm or 62.5/125 µm
IEC 61850, DNP3.0
Rapid spanning tree protocol (RSTP)
Self-healing protocol (SHP)
Dual homing protocol (DHP)
Parallel Redundancy Protocol (PRP)
1300 nm
Typ.
-33.5
-34.5
-11.8
P54A/B/C/E
Max. Unit
–31 dBm avg.
-31.8 Bm avg.
dBm avg.
P54xMED-TM-EN-1