Ipv6 Pim Commands; Bidir-Pim Enable (Ipv6 Pim View); Bidir-Rp-Limit (Ipv6 Pim View) - HP 5900 Series Command Reference Manual

IPv6 PIM commands

The term "interface" in this chapter collectively refers to VLAN interfaces and Layer 3 Ethernet interfaces.
You can set an Ethernet port as a Layer 3 interface by using the port link-mode route command (see
Layer 2—LAN Switching Configuration Guide).

bidir-pim enable (IPv6 PIM view)

Use bidir-pim enable to enable IPv6 BIDIR-PIM.
Use undo bidir-pim enable to disable IPv6 BIDIR-PIM.
Syntax
bidir-pim enable
undo bidir-pim enable
Default
IPv6 BIDIR-PIM is disabled.
Views
IPv6 PIM view
Predefined user roles
network-admin
Usage guidelines
This command takes effect only when IPv6 multicast routing is enabled.
Examples
# Enable IPv6 multicast routing on the public network, and enable IPv6 BIDIR-PIM.
<Sysname> system-view
[Sysname] ipv6 multicast routing
[Sysname-mrib6] quit
[Sysname] ipv6 pim
[Sysname-pim6] bidir-pim enable
Related commands
ipv6 multicast routing

bidir-rp-limit (IPv6 PIM view)

Use bidir-rp-limit to configure the maximum number of RPs in BIDIR-PIM.
Use undo bidir-rp-limit to restore the default.
Syntax
bidir-rp-limit limit
undo bidir-rp-limit
299