Ipv6 Pim-Snooping Graceful-Restart Neighbor-Aging-Time; Reset Ipv6 Pim-Snooping Statistics - HP 5900 Series Command Reference Manual

Related commands
ipv6 pim-snooping enable

ipv6 pim-snooping graceful-restart neighbor-aging-time

Use ipv6 pim-snooping graceful-restart neighbor-aging-time to set the aging time for IPv6 PIM snooping
global neighbor ports on the new master device in IRF master election.
Use undo ipv6 pim-snooping graceful-restart neighbor-aging-time to restore the default.
Syntax
ipv6 pim-snooping graceful-restart neighbor-aging-time interval
undo ipv6 pim-snooping graceful-restart neighbor-aging-time
Default
The default setting is 105 seconds.
Views
VLAN view
Predefined user roles
network-admin
Parameters
interval: Sets an aging time in the range of 105 to 18000 seconds.
Usage guidelines
A global neighbor port is a Layer 2 aggregate interface that acts as a neighbor port.
You must enable IPv6 PIM snooping for a VLAN before you execute this command for the VLAN.
Examples
# In VLAN 2, set the aging time for IPv6 PIM snooping global neighbor ports to 300 seconds on the new
master device in IRF master election.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] ipv6 pim-snooping enable
[Sysname-vlan2] ipv6 pim-snooping graceful-restart neighbor-aging-time 300
Related commands
ipv6 pim-snooping enable

reset ipv6 pim-snooping statistics

Use reset ipv6 pim-snooping statistics to clear statistics for the IPv6 PIM messages learned through IPv6
PIM snooping.
Syntax
reset ipv6 pim-snooping statistics
244