Ipv6 Pim Holdtime Join-Prune - HP 5900 Series Command Reference Manual

<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ipv6 pim hello-o
Related c ommands
hello-option lan-delay (IPv6 PIM view)
•
hello-option override-interval (IPv6 PIM
•
ipv6 pim hello-option lan-delay
•
ipv6 p im holdtime join-prune
Use ipv6 pim holdtime join-prune to set the joined/pruned state holdtime timer on an interface.
Use undo ipv6 pim holdtime join-pr
Syntax
ipv6 pim holdtime join-prune time
undo ipv6 pim holdtime join-prune
Default
The joined/pr
Views
Inte rface view
Predefined user roles
network-admin
Parameters
time: Sets a joined/pruned state holdtime timer in the range of 1 to 65535 seconds.
Usage gu idelines
You can set the joined/pruned state holdtime timer for all interfaces in IPv6 PIM view or for the current
interface in interface view. The configuration m
m ade in IPv6 PIM view.
To prevent the upstream neighbors from aging out, you must configure the join/prune in
than the joined/pruned sta
Examples
# Set the joined/pruned state holdtime timer to 280 seconds on VLAN-in
<Sysname>
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface100]
Related commands
• holdtime join-prune (IPv6 PIM vi
ipv6 pim timer join-prune
•
u ned state holdtime timer is 210 seconds.
te holdtime timer.
system-view

ipv6 pim holdtime join-prune 280

ption override-interval 2000
view)
une to restore the default.
ade in interface view takes priority over the configuration
00
ew)
331
terval to be less
terface 100.