Ipv6 Pim Triggered-Hello-Delay - HP 5900 Series Command Reference Manual

Predefined user roles
network-admin
Paramete rs
interval: S ets a join/prune interval in the range of 0 to 18000 seconds. If you set the value to 0 seconds,
the interface does not send join or prune messages.
Usage gu idelines
You can set the join/prune interval for all interfaces in IPv6 P
interface view. The configuration made in interface view take
IPv6 PIM view.
The configuration takes effect after the current interval ends.
To prevent the upstream neighbors from aging out, you must configure the interval for sending join/prune
messages to be less than the joined/pruned state holdtime timer.
Examples
# Set the join/prune interval to 80 seconds on VLAN-interface 100.
<Sysname>
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ip
Related c ommands
• ipv6 pim holdtime join-prune
timer join-prune (IPv6 PIM view)
•

ipv6 pim triggered-hello-delay

Use ipv6 pim triggered-hello-delay to set the triggered hello delay.
Use undo ipv6 pim triggered-hello-del
Syntax
ipv6 pim triggered-hello-delay delay
undo ipv6 pim triggered-hello-delay
Default
The triggered h
Views
Interface view
Predefined u ser roles
network-admin
Parameters
delay: Sets a triggered hello delay in the range of 1 to 60 seconds.
Usage guid elines
The triggered hello delay defines the maximum delay for sending a he
system-view
ello delay is 5 seconds.
v6 pim timer join-prune 80
ay to restore the default.
336
IM view or for the current interface in
s priority over the configuration made in
llo message.