Igmp-Snooping Report Source-Ip - HP 5900 Series Command Reference Manual

Examples
# In VLAN 2, enable IGMP snooping, and se
<Sysname> system-view
[Sysname]
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enabl
[Sysname-vlan2] igmp-snooping query
Related c ommands
• enable (IGMP-snoop
igmp-snooping enable
•
igmp-snooping max-response-time
•
igmp-snooping querier
•
max-response-time
•

igmp-snooping report source-ip

Use igmp-snooping report source-ip to
Use undo igmp-snooping report source-ip to restore the default.
Syntax
igmp-snooping report source-ip ip-address
undo igmp-snooping report source-ip
Default
The source IP a
interface does n
Views
VLAN view
Predefined user ro les
network-admin
Parameters
ip-address: Specifies a source IP address for IGMP reports.
Usage gu idelines
You must enable IGMP snooping fo
Examples
# In VLAN 2, enable IGMP snooping, and co
<Sysname> system-view
[Sysname]
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping report source-ip 10.1.1.1
igmp-snooping
ing view)
ddress of IGMP reports is the IP address of the current VLAN interface. If the current VLAN
ot have an IP address, the source IP address is 0.0.0.0.
igmp-snooping
t the IGMP general query interval to 20 seconds.
e
-interval 20
configure a source IP address for IGMP reports.
r a VLAN before you execute this command.
nfigure 10.1.1.1 as the source IP address of IGMP reports.
32