Igmp-Snooping Group-Limit; Igmp-Snooping Group-Policy - HP 5900 Series Command Reference Manual

[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping general-query source-ip 10.1.1.1
Related c ommands
enable (IGMP-snooping view)
•
• igmp-snooping enable

igmp-snooping group-limit

Use igmp-snooping group-limit to set the maximum number of multicast groups that a port can join.
Use undo igmp-snooping group-limit to restore the default.
Syntax
igmp-snooping group-limit limit [ vlan vlan-list ]
undo igmp-snooping group-limit [ vlan vlan-list ]
Default
The default setting is 4294967295.
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Predefine d us er roles
network-admin
Paramete rs
limit: Sets the maximum number of multi
4294967295.
vlan vlan-list: Specifies a space-separated list of up to 10 VLAN items. Each item specifies a VLAN by its
ID or a range of VLANs in the form of start-vlan-id to end-vlan-id. The value range for the VLAN ID is 1
to 4094. If you do not specify a VLAN, the command takes
Usage gu idelines
This command takes effect only on the multicast groups that a port joins dynamically.
Examples
# Set the maximum number of multicast groups that
10.
<Sysname> system-view
[Sysname] inter
[Sysname-Ten-GigabitEthernet1/0/1] igmp-snooping group-limit 10 vlan 2
igmp- snooping group-policy
Use igmp-snoop
groups that the r
face ten-gigabitethernet 1/0/1
ing group-policy to configure a multicast group policy on a port to control the multicast
eceiver hosts attached to the port can join.
cast groups that a port can join, in the range of 0 to
effect on all VLANs.
Ten-GigabitEthernet 1/0/1 in VLAN 2 can join to
23