State-Refresh-Rate-Limit (Ipv6 Pim View) - HP 5900 Series Command Reference Manual

Views
IPv6 PIM view
Predefined user roles
network-admin
Paramete rs
interval: Sets a state refresh interval in the range o
Examples
# Set the state refresh interval to 70 s
<Sysname> system-view
[Sysname] ipv6 pim
[Sysname-pim6] state-refresh-interval
Related commands
• ipv6 pim state-refresh-capable
state-refresh-hoplimit (IPv6 PIM view)
•
state-refresh-
•
state- refresh-rate-limit (IPv6 PIM view)
Use state-refresh-rate-limit to
refresh message.
Use undo state-refresh-rate-limit to restore the default.
Syntax
state-refresh-rate-limit time
undo state-refresh-r
Default
The switch waits
Views
IPv6 PIM view
Predefine d user roles
ne twork-admin
Paramete rs
time: Sets an amount of time that the s
of 1 to 65535 seconds.
Examples
# On the public network, set the switch
<Sysname> system-view
[Sysname] ipv6 pim
[Sysname-pim6] state-refresh-rate-lim
econds on the public network.
rate-limit (IPv6 PIM view)
set the amount of time that the switch waits before accepting a new state
ate-limit
30 seconds before it accepts a new state refresh message.
witch waits before accepting a new refresh message, in the range
to wait 45 seconds before it accepts a new state refresh message.
f 1 to 255 seconds.
70
it 45
343