Ipv6 Multicast Boundary - HP 5900 Series Command Reference Manual

Parameters
vpn-instance vpn-instance-name: Specifies an MPLS L3VPN instance by its name, a case-sensitive string
of 1 to 31 characters. If you do not specify a VPN instance, the command displays RPF information for
IPv6 multicast sources on the public network.
ipv6-source-address: Specifies an IPv6 multicast source address.
ipv6-group-address: Specifies an IPv6 multicast group address in the range of FFxy::/16 (excluding
FFx0::/16, FFx1::/16, FFx2::/16, and FF0y::), where "x" and "y" represent any hexadecimal numbers
from 0 to F.
Examples
# Display all RPF information of the multicast source with an IPv6 address 2001::101 on the public
network.
<Sysname> display ipv6 multicast rpf-info 2001::101
RPF information about source 2001::101:
RPF interface: Vlan-interface1, RPF neighbor: FE80::A01:101:1
Referenced prefix/prefix length: 2001::/64
Referenced route type: igp
Route selection rule: preference-preferred
Load splitting rule: disable
Table 83 Command output
Field
RPF information about source 2001::101
RPF interface
RPF neighbor
Referenced prefix/prefix length
Referenced route type
Route selection rule
Load splitting rule
Related commands
display ipv6 multicast forwarding-table
•
display ipv6 multicast routing-table
•

ipv6 multicast boundary

Use ipv6 multicast boundary to configure an IPv6 multicast forwarding boundary.
Description
RPF information of the IPv6 multicast source 2001::101.
Type and number of the RPF interface.
IPv6 address (link-local address) of the RPF neighbor.
Referenced route and its prefix length.
Type of the referenced route:
•
igp—IPv6 IGP unicast route.
•
egp—IPv6 EGP unicast route.
•
unicast (direct) —IPv6 directly connected unicast route.
•
unicast—Other IPv6 unicast route, such as IPv6 unicast
static route.
RPF route selection rule:
•
Route preference.
•
Longest prefix match.
Whether the load splitting feature is enabled.
266