State-Refresh-Interval (Pim View); State-Refresh-Rate-Limit (Pim View) - HP 5900 Series Command Reference Manual

state-refresh-interval (PIM view)

Use state-refresh-interval to set the state refresh interval.
Use undo state-refresh-interval to restore the default.
Syntax
state-refresh-interval interval
undo state-refresh-interval
Default
The state refresh interval is 60 seconds.
Views
PIM view
Predefined user roles
network-admin
Parameters
interval: Sets a state refresh interval in the range of 1 to 255 seconds.
Examples
# Set the state refresh interval to 70 seconds on the public network.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] state-refresh-interval 70
Related commands
pim state-refresh-capable
•
•

state-refresh-rate-limit (PIM view)

state-refresh-ttl (PIM view)
•
state-refresh-rate-limit (PIM view)
Use state-refresh-rate-limit to configure the amount of time that the switch waits before receiving a new
state refresh message.
Use undo state-refresh-rate-limit to restore the default.
Syntax
state-refresh-rate-limit time
undo state-refresh-rate-limit
Default
The switch waits 30 seconds before it receives a new state refresh message.
Views
PIM view
158