IPv6 MCE configuration commands
NOTE:
This chapter describes only the commands related to the IPv6 MCE feature. For information about the
•
routing protocol configuration commands in the configuration examples, see the
Command Reference
•
For information about IPv6 MPLS L3VPN configuration commands, see the chapter "MPLS L3VPN
commands."
display bgp vpnv6 all routing-table
Description
Use the display bgp vpnv6 all routing-table command to display all BGP VPNv6 routing information.
Syntax
display bgp vpnv6 all routing-table [ network-address prefix-length [ longer-prefixes ] | peer ip-address
{ advertised-routes | received-routes } [ statistic ] | statistic ] [ | { begin | exclude | include } regular-
expression ]
View
Any view
Default level
1: Monitor
Parameters
network-address: Specifies the IPv6 address of the destination network segment.
prefix-length: Specifies the length of the prefix, ranging from 0 to 128.
longer-prefixes: Displays each routing entry that meets the following conditions:
Its destination IPv6 address ANDed with the specified prefix equals the specified destination IPv6
•
address ANDed with the specified prefix.
Its prefix length is shorter than or equal to the specified prefix length.
•
Its prefix length is the longest among the entries meeting the above two conditions.
•
peer ip-address: Displays the routing information sent to or received from the specified peer. ip-address is
the IPv4 address of the peer.
advertised-routes: Displays the routing information sent to the specified peer.
received-routes: Displays the routing information received from the specified peer.
statistic: Displays BGP VPNv6 route statistics.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see the Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
.
31
Layer 3—IP Routing