Usage guidelines
This command takes effect only when IPv6 multicast routing is enabled. If the interface belongs to a VPN
instance, make sure IPv6 m
Examples
# Enable IPv6 multicast routing, and enable IPv
<Sysname> system-view
[Sysname]
[Sysname-m
[Sysname] interface
[Sysname-Vlan-interface100] ipv6 pim dm
Related commands
ipv6 multicast routing
ipv6 p
im hello-option dr-priority
Use ipv6 pim hello-option dr-priority to se
Use undo ipv6 pim hello-option dr-prio
Syntax
ipv6 pim hello-option dr-priority prio
undo ipv6 pim hello-option dr-priority
Default
The DR priority
Views
Inte
rface view
Predefine
d user roles
network-ad
min
Paramete
rs
priority: Sets a DR priority in the range of 0 to 4294967295. A larger value represents a higher priority.
Usage guid
elines
You can set the DR priority for all interfaces in IPv6 P
The configuration made in
Examples
# Set the DR priority to 3 on VLAN-interface 100.
<Sysname>
[Sysname] interface vlan-interface
[Sysname-Vlan-interface100] ipv6 pim hello-option dr-priority 3
Related commands
hello-option dr-priority (IPv6 PIM view)
ulticast routing is enabled on the VPN instance.
ipv6 multicast routing
rib6] quit
vlan-interface 100
on an interface is 1.
interface view takes priority over the configuration made in IPv6 PIM view.
system-view
6 PIM-DM on VLAN-interface 100 on the public network.
t the DR priority on an interface.
rity to restore the default.
rity
IM view or for the current interface in interface view.
100
327