Static-Rp (Ipv6 Pim View) - HP 5900 Series Command Reference Manual

Related commands
ipv6 pim state-refresh-capable
•
state-refresh-hoplimit (IPv6 PIM v
•
• state-refresh-interval (IPv6 PIM view

static-rp (IPv6 PIM view)

Use static-rp to configure a stat
Use undo static-rp to remove a static RP.
Syntax
static-rp ipv6-rp-address [ acl6-number | bidir | preferred ] *
undo static-rp ip
Default
No static RP is c
Views
IPv6 PIM view
Predefine d user roles
network-admin
Paramete rs
ipv6-rp-address: Specifies the IPv6
unicast address.
acl6-number: Specifies an IPv6 basic ACL number in
groups. The C-RP is designated only to IPv6 multicast groups that the ACL permits. The static RP is
designated to all IPv6 multicast groups when one of the following conditions exists:
You do not specify an ACL.
•
The specified ACL does not exist.
•
The specified ACL does not contain valid rules.
•
bidir: Specifies IPv6 BIDIR-PIM t
PIM mode is IPv6 PIM-SM.
preferred: Gives priority to the static RP if the static RP and the dynamic RP ex
network. The dynamic RP takes effect only if no static RP exists in the network. If you do not specify this
keyword, the dynamic RP has priority. The static RP takes effect only if no dynamic RP exists in the network
or when the dynamic RP fails.
Usage gu idelines
You do not need to enable IPv6 PIM on an interface that acts as a static RP.
In an IPv6 basic ACL, the source keyword matches the multicast group address in IPv6 multicast packets.
If you specify the vpn-instance keyword in an ACL rule, the rule does not take effect. The other optional
parameters except the
When the ACL rules used by a static RP change, new RPs must be elected for all IPv6 multicast groups.
ic RP.
v6-rp-address
onfigured.
address of the static RP. This address must be a valid IPv6 global
o which the static RP is designated. If you do not specify this keyword, the
time-range keyword and the fragment keyword in the ACL rules are ignored.
iew)
)
the range of 2000 to 2999 to filter IPv6 multicast
344
ist at the same time in the