State-Refresh-Interval (Pim View) - HP 6125XLG Command Reference Manual

Usage guidelines
CAUTION:
If the device is an RP, disabling switchover to SPT might cause multicast traffic forwarding failures on the
source-side DR. When disabling switchover to SPT, be sure you fully understand its impact on your
network.
The source field in an ACL specifies the multicast group range. If you specify a VPN instance in the ACL,
the ACL does not take effect. The other optional parameters except the fragment keyword and the
time-range keyword are ignored.
Examples
# Disable switchover to SPT on a receiver-side DR.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] spt-switch-threshold infinity

state-refresh-interval (PIM view)

Use state-refresh-interval to configure the interval for sending state refresh messages.
Use undo state-refresh-interval to restore the default.
Syntax
state-refresh-interval interval
undo state-refresh-interval
Default
The interval for sending state refresh messages is 60 seconds.
Views
PIM view
Predefined user roles
network-admin
Parameters
interval: Specifies the interval (in seconds) for sending state refresh messages, in the range of 1 to 255.
Examples
# Set the interval for sending state refresh messages to 70 seconds.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] state-refresh-interval 70
Related commands
pim state-refresh-capable
•
state-refresh-rate-limit (PIM view)
•
• state-refresh-ttl (PIM view)
90