D-Link xstack DGS-3620 series Reference Manual page 340

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Restrictions
Only Administrator-level users can issue this command. (EI Mode Only Command)
Example
Configure BGP to show global information:
DGS-3620-28PC:admin# debug bgp show global_info
Command: debug bgp show global_info
Following is the information for global debugging:
---------------------------------------------------
AS Number
Router ID
Cluster ID
Confed ID
Confederation Peers
Fast External Fallover
Dampening Ability
Client to Client Ability
Cluster Peers : 0.0.0.0, 0.0.0.0, peer1
Aggregate Next_Hop_Check
Default Local Preference
Default Holdtime
Default Keepalive
Scan Time
BGP Active Flags:
BGP_AF_CFLAG_SYNCHRONIZATION
BGP_AF_CFLAG_NETWORK_SYNC
BGP Active Redist-Flags for IPv4 Unicast:
BGP Trap
DGS-3620-28PC:admin#
20-43 debug bgp show peer
Description
This command is used for displaying information of all peers in BGP protocol DB.
Format
debug bgp show peer {ipv6 unicast}
Parameters
ipv6 unicast – (Optional) Specifies to debug the IPv6 unicast address family.
: 100
: 194.17.0.2
: 123.123.123.123
: 0
:
: Disabled
: Disabled
: Enabled
: Disabled
: 100
: 40
: 10
: 60
: None
335