Initial Startup - Siemens MASS 2100 Operating Instructions Manual

Commissioning
6.3 Local commissioning
The elements are actuated by touching the glass panel on the appropriate key. Pressing harder
will not activate the key, but using a thumb instead of a finger tip will help. The text display
above the operating elements gives a menu-guided operation of the individual device function/
parameters. Successful operation of the key is confirmed by a small green LED at the right of
the display.
①
②
③
Figure 6-1
Note
(Re-)calibration of the keypad
When the lid is closed, all keys are (re-)calibrated (< 5 seconds). During (re-)calibration the
LED is on and the keys cannot be operated.
If one of the keys is pressed for more than 10 seconds, the (re-)calibration of this key begins
which has a duration of less than 10 seconds. Release the key for further operation.
Note
HMI timeout
If no key is pressed for 10 minutes, the display switches to show operation view. If Backlight
is set to Automatic, display backlight goes off automatically 30 seconds after the last keypress.
Note
Operation does not require opening of the device. This means that the high degree of protection
of IP67 and safety in hazardous areas are guaranteed at all times.
6.3.3

Initial startup

The first time the device is powered up, you will be prompted to set the language. The device
always starts up showing "Language" in English. When the language has been set, you will
be prompted to set the date and time.
94
Full graphical display
LED (for indication of key operation)
Touch keypad
Local display
MASS 2100 & FC300 (FCT030)
Operating Instructions, 06/2017, A5E39789040-AA