Fault Codes And Corrective Actions - Siemens MASS 2100 Operating Instructions Manual

Diagnosing and troubleshooting

10.2 Fault codes and corrective actions

SIMATIC PDM / PLC
Icon Device Pri‐
status ority
Process 8
value
alarm
Process 9
value
warning
10.2 Fault codes and corrective actions
Alarms and system messages support both Siemens standard alarm classes and NAMUR
status signals.
In the following tables the alarm IDs (identification numbers) are listed along with possible
causes and directions for corrective action.
188
NAMUR NE 107
Icon Device Pri‐
status ority
Out of 4
specifica‐
tion
Out of 4
specifica‐
tion
Description
Deviations from permissible ambient
or process conditions determined by
device (through self-monitoring, or
faults in device) indicate that meas‐
urement is uncertain, or deviations
from set value in actuators is proba‐
bly greater than expected under nor‐
mal operating conditions.
Process or ambient conditions will
damage device or result in uncertain
output.
Deviations from permissible ambient
or process conditions determined by
device (through self-monitoring, or
warnings in device) indicate that
measurement is uncertain, or devia‐
tions from set value in actuators is
probably greater than expected un‐
der normal operating conditions.
Process or ambient conditions could
damage device or result in uncertain
output.
Operating Instructions, 06/2017, A5E39789040-AA
Measure
Check ambient tempera‐
ture or process conditions.
If possible, relocate de‐
vice.
Check ambient tempera‐
ture or process conditions.
If possible, relocate de‐
vice.
MASS 2100 & FC300 (FCT030)