Replacing The Device; Return Procedure - Siemens MASS 2100 Operating Instructions Manual

Service and maintenance

9.6 Return procedure

9.5

Replacing the device

If the equipment has been used for measuring corrosive substances there is a risk of chemical
burns when disassembling.
Corrosive substances
Risk of chemical burns when replacing the sensor.
The sensor in the device contains corrosive substances that result in burns on unprotected
skin.
● Make sure that the sensor enclosure is not damaged when replacing the sensor.
● If contact with the corrosive substances occurs, rinse the affected skin immediately with
9.6 Return procedure
Enclose the bill of lading, return document and decontamination certificate in a clear plastic
pouch and attach it firmly to the outside of the packaging.
Required forms
● Delivery note
● Return goods delivery note
returngoodsnote)
with the following information:
– Product (item description)
– Number of returned devices/replacement parts
– Reason for returning the item(s)
● Decontamination declaration (http://www.siemens.com/sc/declarationofdecontamination)
With this declaration you warrant "that the device/replacement part has been carefully
cleaned and is free of residues. The device/replacement part does not pose a hazard for
humans and the environment."
If the returned device/replacement part has come into contact with poisonous, corrosive,
flammable or water-contaminating substances, you must thoroughly clean and
decontaminate the device/replacement part before returning it in order to ensure that all
hollow areas are free from hazardous substances. Check the item after it has been cleaned.
Any devices/replacement parts returned without a decontamination declaration will be
cleaned at your expense before further processing.
172
CAUTION
large amount of water to dilute substance.
(http://www.siemens.com/processinstrumentation/
Operating Instructions, 06/2017, A5E39789040-AA
MASS 2100 & FC300 (FCT030)