Siemens MASS 2100 Operating Instructions Manual page 446

Default settings
B.9 Maintenance and diagnostics
HMI menu ID Parameter
3.5.4.3 Timestamp at minimum
3.5.4.4 Maximum
3.5.4.5 Timestamp at maximum Timestamp at maximum
3.5.4.6 Reset
3.6 Characteristics
3.6.1 SIL variant
3.6.2 CT variant
3.6.3 CT active
3.6.4 Transmitter
3.6.4.1 Design
3.6.4.2 Hazardous Area Appro‐
val
3.6.6 Sensor
3.6.6.1 Hazardous area appro‐
val
3.6.6.2 Maximum mass flow ca‐
pacity
3.6.6.3 Calibration factor
3.6.6.4 Density calibration offset Factory-set density calibration
3.6.6.5 Density calibration factor Factory-set density calibration
3.6.6.6 Dens. comp. tube temp. Factory-set tube temperature
3.6.6.7 Dens. comp. frame
temp.
3.6.6.8 Wetted materials
3.6.7 Fraction order code
446
Description
Timestamp at minimum
Maximum value measured.
The peak values will be reset to
current values.
Specifies whether the device is
allowed to be used in Safety ap‐
plications
Specifies whether the device is
allowed to be used in Custody
Transfer applications
Specifies whether the device is
in Custody Transfer mode
Describes the main design fea‐
ture of the transmitter.
Describes the hazardous area
approval for the transmitter. The
text can also be found on the la‐
bel of the product.
Defines gas classes and hazard‐
ous zones applicable for the sen‐
sor.
Maximum mass flow measure‐
ment capacity of the sensor.
Factory-set calibration factor.
offset.
factor.
compensation for density calcu‐
lation.
Factory-set frame temperature
compensation for density calcu‐
lation.
Type of wetted material of the
sensor.
Order code of the active fraction.
Default value Value range
[unit]
Yes or No
● Yes
● No
Yes or No ● Yes
● No
[kg/h]
MASS 2100 & FC300 (FCT030)
Operating Instructions, 06/2017, A5E39789040-AA
Access
level
Read
only
Read
only
Read
only
User
Read
only
Read
only
Read
only
Read
only
Read
only
Read
only
Read
only
Read
only
Read
only
Read
only
Read
only
Read
only
Read
only