Sensor Diagnostic Events - Siemens MASS 2100 Operating Instructions Manual

10.2.1

Sensor diagnostic events

Sensor diagnostic events
ID/ Diagnostic
Icons
32 SIL parameters not validated
33 SIL parameters not validated
34 SIL parameters not validated
35 SIL parameters not validated
36 Sensor supply volt. out of range
37 Sensor supply volt. out of range
38 Temperature measurement fault Turn off the power, wait 5 seconds and turn on
39 Temperature measurement fault Turn off the power, wait 5 seconds and turn on
MASS 2100 & FC300 (FCT030)
Operating Instructions, 06/2017, A5E39789040-AA
Action
Run the 'Safety Validation' wizard to validate the
safety-critical parameters. The device can be
put into Safe Operation mode after validation
Run the 'Safety Validation' wizard to validate the
safety-critical parameters. The device can be
put into Safe Operation mode after validation
Run the 'Safety Validation' wizard to validate the
safety-critical parameters. The device can be
put into Safe Operation mode after validation
Run the 'Safety Validation' wizard to validate the
safety-critical parameters. The device can be
put into Safe Operation mode after validation
Contact your local Siemens representative
Contact your local Siemens representative
the power again. If the failure continues then
contact your local Siemens representative
the power again. If the failure continues then
contact your local Siemens representative
Diagnosing and troubleshooting
10.2 Fault codes and corrective actions
Comments
189