Siemens MASS 2100 Operating Instructions Manual page 116

Operating MASS 2100/FC300 with FCT030
7.2 Operating instructions
Navigating the navigation view
Browse the navigation view and menu items using the control buttons as follows:
Table 7-8
Key
Editing the parameters
When this symbol
changing the parameters as described below.
Table 7-9
Key
Table 7-10
Key
116
Navigation view
Function
Enter the next higher level of the navigation view (for example from level 2 to level 1).
If located on level 1 in the navigation view then enter the operation view.
Select the item above in the list; keep pressing the key to accelerate scrolling up the
selection list. If the key is pressed when the top item is selected, the bottom item will be
highlighted.
Select the item below in the list; keep pressing the key to accelerate scrolling down the
selection list. If the key is pressed when the bottom item is selected, the top item will be
highlighted.
Enter the next lower level of the navigation view (for example from level 1 to level 2).
If a parameter is selected in the navigation view then enter the parameter view.
is shown in the graphics, the four buttons on the HMI are used for
Parameter edit view
Function
Select the next left position.
If the most left position is selected, exit the parameter edit view without confirming the
changes. Keep pressing the key to jump to the most left position.
Change the selected number/character.
Numeric characters: increase the number by one (for example from 7 to 8)
ASCII characters: select the previous character in the alphabet.
Change the selected number/character.
Numeric characters: decrease the number by one (for example. from 8 to 7)
ASCII characters: select the next character in the alphabet.
Select the next right position.
If most right position is selected, confirm the change and exit the parameter edit view.
Keep pressing the key to jump to the most right position.
Parameter read only view
Function
Exit parameter edit view
No functionality
No functionality
No functionality
MASS 2100 & FC300 (FCT030)
Operating Instructions, 06/2017, A5E39789040-AA