Advertisement
Please refer to the Instruction Manual prior to installation and startup!
L | Keyboard and Function value |
Measured value, Unit (M12 and M14), status | |
Error and fault codes in case of malfunction | |
M4 | Damping1)2) |
M7 | Zero adjustment3)2) |
M10 | Key and function disable1)5)2) |
M13 | Measured value source1)2) |
M14 | Physical unit1)3)2) |
M15 | Bus address1)2) |
M16 | Device operation mode1)2) |
M17 | Decimal point1)2) |
M18 | Zero adjustment4) |
M19 | Balance LO1)3)2) |
M20 | Balance HI1)3)2) |
1) UP or DOWN change value
2) MODE save value
3) UP and DOWN 2s set value
4) Only display of remaining available measuring range
5) UP and DOWN 2s lock off
F_001 | Key and function disable |
F_003 | Change of device mode currently not permitted |
F_004 | Decimal point unfavourable |
F_005 | Value is read-only |
F_006 | Balance span too small |
F_007 | Measuring range limited |
F_008 | Local operation disabled |
B_004 | Balance span too small |
B_011 | Value not calculated |
B_012 | Electronics defective |
B_015 | Electronics defective, value constant |
B_016 | Sensor error |
B_017 | Lower overrange limit reached |
B_018 | Upper overrange limit reached |
B_031 | Out of service |
U_071 | Last usable value |
U_072 | Substitute value |
U_075 | Substitute value constant |
U_079 | Initial value |
U_080 | Maintenance alarm |
U_081 | Lower measuring range reached |
U_082 | Upper measuring range reached |
Good | |
G_132 | Parameter changed |
G_137 | Lower warning limit reached |
G_138 | Upper warning limit reached |
G_141 | Lower alarm limit reached |
G_142 | Upper alarm limit reached |
G_164 | Maintenance required |
0 | Output |
1 | Secondary variable (Pressure) |
2 | Primary variable |
3 | Sensor temperature |
4 | Electronics temperature |
5 | Secondary variable 3 |
6 | Counter output |
7 | Sensor pressure value |
0 | Profile 3.0 device (1AI) |
1 | SITRANS P DS III PA Profile 3.0 |
128 | Profile 3.0 Gerät (1AI, 1TOT) |
Can be read from the approval label
FW: aaaa. bb. cc
HW: xx. yy. zz
See operation instructions, type plate and certificate of conformity http://www.siemens.com/sitransp
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Advertisement
Need help?
Do you have a question about the SITRANS P300 and is the answer not in the manual?
Questions and answers