Fault Codes And Corrective Actions; Alarm Messages - Siemens SITRANS F Operating Instructions Manual

Diagnosing and troubleshooting

9.3 Fault codes and corrective actions

Icon Priority
level
3
3
2
NAMUR status signals
Icon Priority
level
1
3
4
2
Info icons
Icon Name
Read only
Data exchange
9.3 Fault codes and corrective actions
9.3.1

Alarm messages

Alarms and system messages support both Siemens standard alarm classes and NAMUR
status signals.
62
Name Description
Process value error
● Process value has reached an alarm limit
Process value warning ● Process value has reached a warning limit
Function check ● Change of configuration, local operation, or substitute value entered
● Output signals are temporarily invalid
Name Description
Failure
● Failure
● Invalid output signal
Out of specification
● Out of specification
● Device will still work, but output signals may be invalid
Maintenance required
● Maintenance request
● Measured signal still valid
Function check
● Function check
● Output signal temporarily invalid
Description
● Write access disabled
● Indicate read only parameters
● Device is communicating
FST020 IP65 NEMA 4X
Operating Instructions, 09/2017, A5E41425845-AB