Table of Contents
Advertisement
Install the rack rails and server tray
These rack rails can be installed in both round- or square-hole racks.
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
•
Left and right rack rail assemblies – These rails occupy 1U position on the rack.
•
Server tray
•
T-15 Torx screwdriver
Procedure
1. Disassemble the rail assemblies:
a. Pull out the inner rail until it is fully extended .
b. Slide and hold the white release tab in the direction shown, and then remove the inner sliding rail from
the outer mounting rail.
50
Hardware options installation
Advertisement
Table of Contents
