Select which signal to monitor with Pn080 = n.X (Calculation Method for Maximum Speed or Divided Out-
put Pulses).
• If Pn080 = n.0, the encoder output resolution (Pn281) that can be set is displayed.
• If Pn080 = n.1, the maximum motor speed (Pn385) that can be set is displayed in mm/s.
*2.
This applies to the following motors. The display will show 0 for all other models.
SGM7A, SGM7J, SGM7G, SGM7P, and SGMCV
15.2 Corresponding SERVOPACK and SigmaWin+ Function Names
15.2.2 Corresponding SERVOPACK Monitor Display Function Names
15
15-11