Table of Contents
Advertisement
Click the No Button to cancel writing the motor parameters to the linear encoder.
If you click the Yes Button, writing the motor parameter scale will start.
9.
Click the Complete Button.
10.
Click the OK Button.
11.
Turn the power supply to the SERVOPACK OFF and ON again.
This concludes the procedure to write the motor parameters.
Confirming If the Motor Parameters Have Been Written
After you write the motor parameters, you can use a monitor function to confirm that the motor
parameters are in the encoder.
If the motor parameters have not been written, no information on the Servomotor will be dis-
played.
9.1 Monitoring Product Information on page 9-2
5.8 Writing Linear Servomotor Parameters
5
5-23
Advertisement
Table of Contents
Troubleshooting
