Siemens CU230P-2 HVAC Parameter Manual page 472

Signal targets for STW1 in Interface Mode SINAMICS (p2038 = 0)
Signal Meaning
= ON (pulses can be enabled)
STW1.0
0 = OFF1 (braking with ramp-function generator, then pulse cancllation & ready-to-power-up)
1 = No OFF2 (enable is possible)
STW1.1
0 = OFF2 (immediate pulse cancellation and power-on inhibit)
1 = No OFF3 (enable is possible)
STW1.2
0 = OFF3 (braking with the OFF3 ramp p1135, then pulse cancellation and power-on inhibit)
1 = Enable operation (pulses can be enabled)
STW1.3
0 = Inhibit operation (cancel pulses)
1 = Operating condition (the ramp-function generator can be enabled)
STW1.4
0 = Inhibit ramp-function generator (set the ramp-function generator output to zero)
1 = Enable the ramp-function generator
STW1.5
0 = Stop the ramp-function generator (freeze the ramp-function generator output)
1 = Enable setpoint
STW1.6
0 = Inhibit setpoint (set the ramp-function generator input to zero)
STW1.7 = Acknowledge faults
STW1.8 Reserved
STW1.9 Reserved
STW1.10 1 = Control via PLC
STW1.11
1 = Dir of rot reversal
Reserved
STW1.12
STW1.13 1 = Motorized potentiometer, setpoint, raise
STW1.14 1 = Motorized potentiometer, setpoint, lower
STW1.15 Reserved
Used in telegrams 1, 352.
<1>
<2> Bit 10 in STW1 must be set to ensure that the drive accepts the process data.
1 2
PROFIdrive / PROFIBUS
STW1 control word interconnection (p2038 = 0)
<2>
3 4
[Function diagram] [Function diagram]
Interconnection
internal control word
parameters
p0840[0] = r2090.0 [2501.3] Sequence control
p0844[0] = r2090.1 [2501.3] Sequence control
p0848[0] = r2090.2 [2501.3]
Sequence control
Sequence control
p0852[0] = r2090.3 [2501.3]
p1140[0] = r2090.4 [2501.3] [3060] [3070] [3080]
p1141[0] = r2090.5 [2501.3]
p1142[0] = r2090.6 [2501.3] [3060] [3070] [3080]
p2103[0] = r2090.7 [2546.1]
- -
- -
p0854[0] = r2090.10 [2501.3]
p1113[0] = r2090.11 [2505.3]
- -
p1035[0] = r2090.13 [2505.3]
p1036[0] = r2090.14 [2505.3]
- -
5 6
Function diagram
FP_2442_97_51.vsd
G120 CU230P-2 DP
29.10.2009 V4.3
<1>
Inverted
signal target
-
-
-
-
-
[3060] [3070] -
-
[8060] -
- -
- -
[2501] -
[3040]
-
- -
[3020] -
[3020] -
-
-
7 8
- 2442 -