Siemens CU230P-2 HVAC Parameter Manual page 379

p20211 BSW 0 run-time group / BSW 0 RTG
Access level: 3
Can be changed: T
Min
1
Description: Setting parameter for the run-time group in which the instance BSW 0 of the binary changeover switch is to be
called.
Value: 1:
2:
3:
4:
5:
6:
9999: Do not calculate
p20212 BSW 0 run sequence / BSW 0 RunSeq
Access level: 3
Can be changed: T
Min
0
Description: Setting parameter for the run sequence of instance BSW 0 within the run-time group set in p20211.
Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run
sequence value.
p20213[0...1] BI: BSW 1 inputs / BSW 1 inputs
Access level: 3
Can be changed: T
Min
-
Description: Sets the signal source of input quantities I0 and I1 of instance BSW 1 of the binary changeover switch.
Index: [0] = Input I0
[1] = Input I1
p20214 BI: BSW 1 switch setting I / BSW 1 sw_setting
Access level: 3
Can be changed: T
Min
-
Description: Sets the signal source of the switch setting I of instance BSW 1 of the binary changeover switch.
r20215 BO: BSW 1 output Q / BSW 1 output Q
Access level: 3
Unit: -
Description: Display parameter for output quantity Q of instance BSW 1 of the binary changeover switch.
© Siemens AG 2009 All Rights Reserved
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 11/2009
Run-time group 1
Run-time group 2
Run-time group 3
Run-time group 4
Run-time group 5
Run-time group 6
Calculated: -
Scaling: -
Max
9999
Calculated: -
Scaling: -
Max
7999
Calculated: -
Scaling: -
Max
-
Calculated: -
Scaling: -
Max
-
Calculated: -
Scaling: -
Parameters
List of Parameters
Data type: Integer16
Data set: -
Factory setting
9999
Data type: Unsigned16
Data set: -
Factory setting
580
Data type: U32 / Binary
Data set: -
Factory setting
0
Data type: U32 / Binary
Data set: -
Factory setting
0
Data type: Unsigned32
Data set: -
1-379