Siemens CU230P-2 HVAC Parameter Manual page 333

r9451[0...29] Units changeover adapted parameters / Unit_chngov par
Access level: 4
Unit: -
Description: Displays the parameters whose parameter would have to be changed during a units changeover.
p9484 BICO interconnections search signal source / BICO S_src srch
Access level: 4
Can be changed: T
Min
0
Description: Sets the signal source (BO/CO parameter, BICO coded) to search in the signal sinks.
The signal source to be searched for is set in p9484 (BICO-coded) and the search result is specified using the num-
ber (r9485) and the first index (r9486).
Dependency: Refer to: r9485, r9486
r9485 BICO interconnections signal source search count / BICO S_src srchQty
Access level: 4
Unit: -
Description: Displays the number of BICO interconnections to the signal sink being searched for.
The signal source to be searched for is set in p9484 (BICO-coded) and the search result is specified using the num-
ber (r9485) and the first index (r9486).
Dependency: Refer to: p9484, r9486
r9486 BICO interconnections signal source search first index / BICO S_src srchIdx
Access level: 4
Unit: -
Description: Displays the first index of the signal source being searched for.
The signal source to be searched for is set in p9484 (BICO-coded) and the search result is specified using the num-
ber (r9485) and the first index (r9486).
Dependency: Refer to: p9484, r9485
r9925[0...99] Firmware file incorrect / FW file incorr
Access level: 3
Unit: -
Description: Displays the directory and name of the file whose status as shipped from the factory was identified as impermissi-
ble.
Dependency: Refer to: r9926
Refer to: A01016
Note: The directory and name of the file is displayed in the ASCII code.
r9926 Firmware check status / FW check status
Access level: 3
Unit: -
Description: Displays the status when the firmware is checked when the system is booted.
0: Firmware not yet checked.
1: Check running.
2: Check successfully completed.
3: Check indicates an error.
Dependency: Refer to: r9925
Refer to: A01016
© Siemens AG 2009 All Rights Reserved
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 11/2009
Calculated: -
Scaling: -
Calculated: -
Scaling: -
Max
4294967295
Calculated: -
Scaling: -
Calculated: -
Scaling: -
Calculated: -
Scaling: -
Calculated: -
Scaling: -
Parameters
List of Parameters
Data type: Unsigned32
Data set: -
Data type: Unsigned32
Data set: -
Factory setting
0
Data type: Unsigned16
Data set: -
Data type: Unsigned16
Data set: -
Data type: Unsigned8
Data set: -
Data type: Unsigned8
Data set: -
1-333